Use the checklists in the Outdoor Visual Leak Inspection ( Section 2) and Indoor Visual Leak Inspection ( Section 3) to conduct visual leak inspections around your home. Visual Inspection MethodД¬onduct the Visual Inspection Method if you did not detect a continuous leak when you performed the Leak Detection Test ( Section 1) or if you are uncomfortable with the Isolation Method. If you are comfortable turning valves on and off, go to Isolation Method for Continuous Leaks ( Section 4). These numbers come from combining the sweep hand reading with the odometer reading.The meter reads 81710.03. You will turn water supply valves 'off' to prevent water from flowing into water supply pipes. 192 part of the reading might be a little confusing. sequences and procedures and for coordinating parts of the Services under the Contract. This is often the quickest way to locate ongoing, hard-to-find leaks. The majority of the Citys water meters are Sensus water meters. If your Leak Detection Test ( Section 1) indicated a continuous leak, consider using the Isolation Method to discover the leak location. The purpose of the Isolation Method is to isolate different sections of the plumbing in and around your home. remote reading systems are available for all SR II Low Lead Water Meters. A brief description of both methods follows. Sensus SR II Low Lead Water Meters consist of three basic components: maincase. This guide provides two methods to detect the location of leaks: the Isolation Method and the Visual Inspection Method. To determine if you have a slow leak follow Step 3 above.

Some leaks are very slow and may not show as a continuous flow.

If the number is greater than zero on any of the flashes, you have a continuous leak.

Observe the flow rate screen for at least 10 flashes.

If Gallons Used is greater than zero you have a continuous leak.

Subtract the first water meter reading from the second.Then replace the last digit of that number with the number the meter's needle is closest to.

If you have an older, analog meter, write down the number thatвЂ™s displayed on its large, circular dial.

Wait 20 minutes then read your water meter again and record the numbers. To read a water meter, start by removing its cover.

Use the number indicated by the sweep arm as the final digit.

Read your water meter and record the numbers in the boxes we've provided (' Fill in your meter readings Fill in your meter readings').

Some leaks are so small that the movement is almost undetectable. We have a complete range of products including water meters, gas meters, electricity meters and more that help you build intelligence into every point of. If it is moving, you have a continuous leak.

new meters will automatically transmit meter readings to a secure Sensus data. Step-by-Step Instructions For Analog Display Meters The Town of East Lyme Water Department is replacing all residential and.

All sensus water meter reading parts